Editing The Audience Region - Martin Audio MLA User Manual

MLA System
USER GUIDE
Then hover over the slice drawing. You will see a green inverted triangle moving left and right along the slice outline
corresponding to the left and right movement of your cursor. Position the triangle where the audience position starts and click
once. Now move the cursor to the right tracing the slice along the audience area and you will see a green line following your
movement with a red inverted triangle at the end of the line. When the red triangle is over the furthest point of the audience
region click again and the audience area is defined. Don't worry at this point that it includes underneath and on the front of
balconies et cetera that is corrected at the next stage.

Editing the Audience Region

If you didn't get either the start or finish points correct it is easy to adjust them by using the Move Coverage Marker buttons,
either the green one for the start position or the red one for the stop position.
Just click on either of the buttons and move the cursor to the correct position, the triangle marker will move for whichever point
you are adjusting without disturbing the other. When you have the point in the correct new position click again to finalise it.
You can also delete the audience region entirely but clicking on the 'Add Audience' button again automatically deletes what you
have already entered allowing you to start again, or click on the Delete Audience button which removes the audience region you
have drawn but you have the option to re-draw a new region at a later time.
Assuming you have drawn an accurate representation of the venue (and remember that the more accurate the D2 project, the
better the audible results), you have now finished entering the venue slice and can click on 'Done' to close the window.
MLA System User Guide V2.1
169