General Troubleshooting Guide - Taylor 336 Service Manual

General Troubleshooting Guide

PROBLEM
1. No product is being dispensed.
2. The product is too thick.
PROBABLE CAUSE
Low on mix. The MIX OUT light is on.
The power switch is in the OFF
position.
Beater motor is out on reset.
Air/mix pump is incorrec tly assembled
or improperly lubricated.
Missing or incorrectly installed spring
and poppet in air/mix pump.
The mix pump ball crank is broke . n
The pump motor is not activated.
Incorrect usage of the mix feed tube
(gravity style freezers).
Insufficient mix in the freezing cylinder.
Improper priming procedures.
The air/mix ump is incorrectly p
assembled.
The viscosity control is set too cold.
REMEDY
Add mix to the mix hopper
Place the power switch to the ON
position and press the AUTO keypad .
Allow the beater motor to cool. Place
the power switch to the OFF position.
Press the reset button firmly. Place the
power switch to the ON position an d
press the WASH keypad. Open the
side access panel and observe that
the drive shaft is turning CLOCKWI E
as viewed from the front of the unit.
Press the AUTO eypad to return to k
the AUTO mode.
Follow assembly procedures carefully.
Replace or correctly install the spr g
and poppet on the mix inlet fitting.
Replace the component.
Push the reset button. The draw valve
must be fully aised to activate the r
pump motor.
Follow the correct feed tube
procedures and use of the air orific . e
Check the air/mix pump assem y.
The mix inlet tube m ust be fully
submerged in mix.
Drain the freezing cylinder and
re-prime the unit.
Follow assembly procedures carefully.
Adjust the viscosity.
S
in
bl