Model 338 Specifications - Taylor 336 Service Manual

Model 338 Specifications

Freezing Cylinder
Two, 2.8 quart (2.7 liter) volume.
Mix Hopper
Two, 20 quart (18.9 liter).
Beater Motor
Two, 1.0 hp.
Refrigeration Unit
One, approximately 9,500 btu/hr compressor. Refrigerant
R404A.
One independent (SHR) compressor, approximately 400
btu/hr. Refrigerant R134a. (BTU's may vary based on
compressor used.)
Electrical
Electrical
Fuse Size
208-230/60/1 Air
208-230/60/1 Water
208-230/60/3 Air
208-230/60/3 Water
This unit is manufactured in other electrical characteristics.
Refer to the Distributor Data Book for
One dedicated connection.
Maximum Minimum
Circuit Ampacity
35 28
35 28
25 19
25 19
availability. (For exact electrical information, always refer to
the data label of the unit.)
Air Cooled
Clearance: 6" (15.2 cm.) on both sides. It is recommended to
install a skirt to one side of the unit, and to place the back of
the unit against a wall. This will assure proper air flow across
condensers to obtain optimum performance.
Water Cooled
Water inlet and drain connections under side of base 3/8"
FPT.
Dimensions
Width: 26-7/16" (67.2 cm.)
Depth: 31-3/16" (79.2 cm.)
Height: 38-3/4" (98.4 cm.)
Counter Clearance: 3-1/2" (8.9 cm.) mounted on
standard legs.
Approximate Weights
Net: 465 Ibs. (219.0kgs.) Crated: 542 Ibs. (245.9 kgs.), 29.9
cu. ft. (.84 cu. m.)
Availability and specifications are subject to change
without notice.
This unit is designed and constructed to meet stringent safety
and sanitation requirements for NSF and UL.