Checks After Starting Engine; Cooling Water; Warming Up Engine; Manual Start And Electric Start Models - Yamaha F30 Owner's Manual

of cranking, return the main switch to
" " (on), wait 10 seconds, then
crank the engine again.
TIP:
When the engine is cold, it needs to be

warmed up. For further information, see
page 61.
If the engine is warm and fails to start,

open the throttle slightly and try to start the
engine again. If the engine still fails to
start, see page 97.
EMU36511

Checks after starting engine

EMU36524

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01811
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
[ECM00193]
EMU27671
EMU27718
Manual start and electric start
models
1.
2.
EMU36532
EMU36542

Shifting

While the boat is tightly moored, and without
applying throttle, confirm that the engine
shifts smoothly into forward and reverse, and
back to neutral.
EMU36981

Stop switches



Warming up engine

After starting the engine, allow it to idle
for 3 minutes to warm up. NOTICE: Fail-
ure to do so will shorten engine life.
[ECM04550]
Be sure the low oil pressure-alert indica-
tor goes off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine
starts, stop the engine. Otherwise,
serious engine damage could occur.
Check the oil level and add engine oil
if necessary. Consult your Yamaha
dealer if the cause for the low oil
pressure alert cannot be found.
[ECM01832]

Checks after engine warm up

Turn the main switch to "
Operation
", or press the
61