Checks After Starting Engine; Cooling Water; Warming Up Engine; Electric Start Models - Yamaha FL200C Owner's Manual

Operation
ON
START
5. Immediately after the engine starts, re-
lease the main switch to return it to "
(on). NOTICE: Never turn the main
switch to "
gine is running. Do not keep the start-
er motor turning for more than 5
seconds. If the starter motor is turned
continuously for more than 5 seconds,
the battery will be quickly discharged,
thus making it impossible to start the
engine. The starter can also be dam-
aged. If the engine will not start after 5
seconds of cranking, return the main
switch to "
then crank the engine again.
EMU36511

Checks after starting engine

EMU36524

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
water from the pilot hole indicates that the
48
ON
START
ZMU04596
ZMU05830
" (start) while the en-
" (on), wait 10 seconds,
[ECM00193]
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01811
NOTICE
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check whether
the cooling water inlet on the lower case
or the cooling water pilot hole is blocked.
Consult your Yamaha dealer if the prob-
lem cannot be located and corrected.
"
EMU27671

Warming up engine

EMU30038

Electric start models

1. After starting the engine, allow it to idle
for 3 minutes to warm up to provide max-
imum operating performance and accel-
eration. Failure to do so will shorten
engine life.
2. Be sure the low oil pressure-alert indica-
tor remains off after starting the engine.
NOTICE: If the low oil pressure-alert
indicator blinks after the engine starts,
stop the engine. Otherwise, serious
engine damage could occur. Check
the oil level and add engine oil if nec-