Din Rail Mounting; Flat Surface Mounting - Johnson Controls S300 Series Hardware Installation Manual

S300-DIN-RDR2S Module

DIN Rail Mounting

To mount an RDR2S module on a DIN rail, align it with the rail and snap on. To
remove a module, pull down the white clip located on the bottom of the module,
then pull the bottom of the module out and lift it up.

Flat Surface Mounting

For flat surface mounting, the RDR2S needs to be disassembled. The base part of
the plastic enclosure has four mounting holes that are used for securing the
enclosure to the wall.
Base part
24-10239-413 Rev. A
This document contains confidential and proprietary information of Johnson Controls, Inc.
© 2010 Johnson Controls, Inc.
Hardware Installation
Mounting Holes
Top part
5