Specification; Routine Maintenance - Johnson Controls S300 Series Hardware Installation Manual

Hardware Installation
Item
Input Power
Lock Output
Reader Interface
General Purpose Inputs
General Purpose Outputs
Communications
Certifications
Mounting Specifications
Dimensions
Ambient Temperature
Humidity
Ventilation
M
AINTENANCE
This chapter provides maintenance instructions, operational testing procedures,
troubleshooting guidelines, and information on replacement parts.

Routine Maintenance

 Perform the following routine maintenance for the RDR2S:
1. Periodically check the continuity of the grounding circuit.
2. Perform operational testing monthly (see "Testing Procedure" on page 37).
3. Replace the lithium battery every five years or after extended (five days)
power interruption (Panasonic CR 2025 or equivalent). See "Real Time
Clock Battery (Lithium Battery) Replacement" on page 37.
4. If installed, replace the lead-acid backup battery every three years (Power
Sonic PS-1270, 12 VDC, 7 Ah for the large enclosure; Power Sonic
PS-1228, 12 VDC, 2.8 Ah for the small enclosure).
36

Specification

24 VDC @ 1.5 amps maximum
12/24 VDC (up to 8 W)
• 2-wire Wiegand (up to 256 bits)
• 5/12/24 VDC (up to 5 W)
• Red indicator
• Green indicator
Resistive load
0-12 VDC
2-wire RS-485
• UL 294 (Access control)
• UL 1076 (Proprietary alarm unit)
• CSA/CUL C22.2 No. 205
• FCC, Class B
• CE Mark
• C-Tick
• DIN rail
• Flat surface
• Field wiring assembly and control electronics are on separate
panels to aid in ease of installation
7 H x 4.5 W x 2.25 D inches
(17.5 cm x 11.25 cm x 5.5 cm)
32º to 122º F (0º to 50ºC)
10 to 85% non-condensing
Cabinets require free movement of air over all exposed surfaces
This document contains confidential and proprietary information of Johnson Controls, Inc.
S300-DIN-RDR2S Module
24-10239-413 Rev. A
© 2010 Johnson Controls, Inc.