Tripp Lite B096-048 Owner's Manual page 128

Check NSCA Enabled, choose an NSCA Encryption Method and enter and confirm an NSCA
Secret. Remember these details as you will need them later on. For NSCA Interval, enter 5
Click Apply.
Next, configure the attached Window network host and specify the services you will be checking with
Nagios (HTTP and HTTPS):
Select Network Hosts from the Serial & Network menu and click Add Host.
Enter the IP Address/DNS Name of the network server, (e.g.: 192.168.1.10) and enter a
Description, (e.g.: Windows 2003 IIS Server)
Remove all Permitted Services. This server will be accessible using Terminal Services, so check
TCP, Port 3389 and log level 1 and click Add. It is important to remove and re-add the service to
enable logging
Scroll down to Nagios Settings and check Enable Nagios
Click New Check and select Check Ping. Click check-host-alive
Click New Check and select Check Permitted TCP. Select Port 3389
Click New Check and select Check TCP. Select Port 80
Click New Check and select Check TCP. Select Port 443
Click Apply
Similarly, configure the serial port to the router to be monitored by Nagios:
Select Serial Port from the Serial & Network menu
Locate the serial port that has the router console port attached and click Edit
Ensure the serial port settings under Common Settings are correct and match the attached
router's console port
Click Console Server Mode and select Logging Level 1
Check Telnet (SSH access is not required, as SDT Connector is used to secure the otherwise
unsecured Telnet connection)
Scroll down to Nagios Settings and check Enable Nagios
Check Port Log and Serial Status
_____________________________________________________________________
B096-016 B096-048 and B092-016 User Manual Page 128