Updating The Firmware - Radio Shack iSCAN PRO-18 User Manual

Updating the Firmware

Firmware updates are available to correct known issues or to add new
functionality to your scanner. Be sure to update the iScan firmware regularly.
CPU Firmware Updates
1. Turn off the iScan and
disconnect the USB cable
from the scanner. Keep the
USB cable connected to your
computer.
2. While pressing the Menu key, connect the USB cable to the iScan. You
should see a display of the current boot and CPU versions followed by
the CPU SW Upgrade prompt.
3. Select Check for CPU Firmware Updates in the update menu.
4. Click Check for Updates on the update screen. This process will check
the Internet for the most current CPU firmware version and compare it
to the version on your iScan. Information about the need to update your
scanner will appear just below the version information.
5. If there are available updates, click Update My Scanner.
6. When you have finished the update, click Done.
DSP Firmware Updates
1. Turn off the iScan.
2. Connect the scanner to your computer using the USB cable supplied.
The computer should recognize the scanner's microSD card as a new
drive. If an autorun screen appears, close it.
3. Select Check for DSP Firmware Update in the update menu.
4. Click Check for Updates on the update screen. This process will check
the Internet for the most current DSP firmware version and compare it
to the version on your iScan. Information about the need to update your
scanner will appear just below the version information.
5. If there are available updates, click Update My Scanner.
6. When you have finished the update, click Done.
2000018.UG.031011.indd 10
10
3/10/2011 11:06:56 AM