Removing A Pcie Adapter From The 9009-41A, 9009-42A, Or 9223-42H System - IBM 9009-41A Manual
Pcie adapters
Hide thumbs
Also See for 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 33. Removing the service access cover
Removing a PCIe adapter from the 9009-41A, 9009-42A, or 9223-42H system
To remove a PCIe adapter from the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. To set the adapter latch (A) at the target slot into the open position, rotate the latch (A) on the rear of
the system as shown.
See Figure 34 on page 47 and Figure 35 on page 48.
(L007)
46 Power Systems: PCIe adapters for the 9009-41A, 9009-42A, or 9223-42H
Advertisement
Table of Contents
