Preparing The 9009-41A, 9009-42A, Or 9223-42H System For Operation After Installing A Pcie Adapter - IBM 9009-41A Manual
Pcie adapters
Hide thumbs
Also See for 9009-41A:
- Manual (194 pages) ,
- Site and hardware planning (164 pages) ,
- Instructions manual (32 pages)
Table of Contents
Advertisement
Figure 14. Installing or replacing a PCIe adapter in the 9009-41A stand-alone system.
Preparing the 9009-41A, 9009-42A, or 9223-42H system for operation after installing a
PCIe adapter
To prepare the system for operation after permanently removing a PCIe adapter, complete the steps in
this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 15 on page 20.
a. Slide the cover (A) onto the system unit.
b. Close the release latch (B) by pushing it in the direction shown.
Installing, removing, and replacing PCIe adapters for the 9009-41A, 9009-42A, and 9223-42H system 19
Advertisement
Table of Contents
