Environmental Requirements For Installation; Setting Up The Apparatus 3 / 7 - Agilent Technologies BIO-DIS Apparatus 3/7 Operator's Manual

3

Setting Up the Apparatus 3 / 7

Environmental Requirements for Installation

• Humidity: max relative humidity 80% for temperatures up to 31 ºC decreasing
• Indoor use only
• Pollution Degree: 2
• Installation Category: II
• Altitude: 2000 m
• Temperature: 5 ºC to 40ºC
• Power: 115/230 V ac, 50/60 Hz, 2 A
Setting up the Apparatus 3 / 7
1 Level the Apparatus 3 / 7 by placing the circular level on the appropriate
2 Ensure the power switch on the rear panel is in the OFF position.
3 Connect the power cord to the power receptacle on the Apparatus 3 / 7 rear
4 Plug the power cord into an electrical outlet of the appropriate voltage.
WARNING
Apparatus 3 / 7 Operator's Manual
linearly to 50% relative humidity at 40ºC
Main supply voltage fluctuations are not to exceed ± 10% of the nominal
supply voltage
vessel carrier. Check for level in the front and rear center and the left and right
sides. Turn the adjustable rubber feet on the bottom of the water bath frame
until the bubble in the level is in the center circle at all four check points.
panel.
Ensure the Apparatus 3 / 7 is configured for the voltage available
in your laboratory.
19