Refilling Flexliner - Graco SaniSpray HP 20 Operation - Repair - Parts

How to Spray

Refilling FlexLiner

When spraying flammable or combustible
disinfectants:
•
Move entire sprayer to a well-ventilated
area and away from flammable or
combustible materials, including
disinfectants, when refilling.
•
Keep disinfectant containers covered
between cup refills.
If sprayer runs out of disinfectant, simply refill
the FlexLiner as follows:
1. Perform Pressure Relief Procedure,
page 10.
18
2. To allow disinfectant to drain from
VacuValve Reservoir, open the
VacuValve Cap.
3. Remove cup assembly from sprayer. Set
sprayer on a rag to capture any
disinfectant that may drip.
4. Separate Cup Lid from Cup Support.
5. Follow steps 3 – 10 in Starting a New
Job, page 13.
ti29721a
3A7649A