If sprayer does not spray, try one of
the steps below:
•
Make certain there is only one FlexLiner
in cup support. It is possible for two liners
to nest tightly together and appear as
only one.
•
Make certain the cup cover is properly
threaded to the cup support. If threads
are visible below the cup cover when
tight, then the cover is cross-threaded.
Fully remove the cup cover and reinstall
to the cup support so no threads are
visible when tight.
ti24454a
•
Repeat steps 2 – 6 on pages 8 – 9 to
ensure all the air is evacuated from the
FlexLiner.
•
Make certain the Prime Pump/Spray
knob is in the Spray position.
333394L
•
Refilling FlexLiner
If sprayer runs out of paint simply separate
the cup support from the cup cover/sprayer
and refill the FlexLiner.
1.
2.
3.
Spray
ti23288a
Start Up
If sprayer still does not spray, perform
steps11 and 11 on page 22. If material
sprays while upside down there is air in
the cup. Repeat steps above.
Unplug sprayer from power source.
Separate the cup support from the cup
cover/sprayer. Set the sprayer upside
down on a flat surface. This will keep the
wet paint in the cup cover.
Follow steps 2 - 12 in Starting a New
Job, page 8 procedure.
ti23369a
11