SMART EQ forfour Owner's Manual page 97

Decreasing the blower speed
X
Press the I button.
Activating/deactivating air-recircula-
tion mode
X
Press the À button.
The indicator lamp above À lights up
when air-recirculation mode is activated.
Switching "Cooling with air dehumidifi-
cation" on or off
The "Cooling with air dehumidification"
function cools and dehumidifies the air
inside the vehicle during warm weather.
The engine must be running in order to use
"Cooling with air dehumidification".
X
To switch on: press the K and
¿ button.
The indicator lamp below ¿ lights up
when the function is activated.
In damp weather, only switch off the "Cooling
with air dehumidification" function briefly.
Otherwise the windows can mist up more
quickly.
Demisting the windscreen
X
Press the ¬ button.
The indicator lamp above ¬ lights up
when the windscreen is being demisted.
Use this setting only until the windscreen is
clear again.
Demisting the rear window
When the rear window heating is activated,
the exterior mirrors are also heated.
X
Press the ¤ button.
The indicator lamp above ¤ lights up
when the rear window heating is activated.
Use this setting only until the rear window is
clear again.
Operating the climate control system
Drying windows that are misted up on the
inside
X
Press the ¿ button.
X
Press the à button.
X
If the windows are still misted up, press
the ¬ button.
Use this setting only until the windows are
clear again.
Drying windows that are misted up on the
outside
X
Switch on the windscreen wipers.
X
Press the ¬ button.
Use this setting only until the windows are
clear again.
Setting the pre-entry climate control at
departure time using the on-board com-
puter
Only for instrument cluster with colour dis-
play:
The "Pre-entry climate control at departure
time" function heats or cools the vehicle
interior before the scheduled departure time.
The climate control runs until approx. 10
minutes after the set departure time.
The vehicle must be connected to the charger
in order to activate pre-entry climate con-
trol. The battery charge and the charge out-
put of the high-voltage battery must be suf-
ficient.
If pre-entry climate control cannot be oper-
ated, a display message is shown in the on-
board computer.
X
Pre-heat/cool and charge
Call up
on-board computer.
X
Press a.
X
Select one of the following settings:
no pre-selection
R
The pre-entry climate control is deacti-
vated.
Two stored departure times
R
X
Departure time > select
vate the stored departure time. If Smart-
Charging was selected before, this setting
is also activated.
in the
Activate
to acti-
Z
95