SMART EQ forfour Owner's Manual page 86

Charging the high-voltage battery
84
Indicator lamp ;
Lights up
green
Indicator lamp =
Lights up
green
Flashes
orange
Indicator lamp ?
Lights up
red
For transportation, wrap the charging cable
around the control panel or secure it to the
control panel housing.
Setting the charging current (only
charging cable version two)
G
WARNING
If the charge current draw via a mains
socket is too high during the charging
process, the external mains supply may
overheat. There is a risk of fire.
Before charging, check the maximum per-
missible charge current available at the
location. If necessary, contact a qualified
specialist company for assistance.
Adjust your vehicle's settings, if neces-
sary.
!
If the charge current is too high, the fuse
could be tripped or the external mains
supply could overheat. Check if the exter-
nal mains supply is equipped to handle the
programmed charge current. If necessary,
reduce the programmed charge current or
use a different mains socket.
You can only limit the charging current for
charging the high-voltage battery with
Voltage is switched on. The
high-voltage battery can
be charged.
High-voltage battery is
charging.
Connection to vehicle has
been made.
The current at the control
panel is not correct. The
high-voltage battery can-
not be charged.
charging cable version 2. This may protect
the mains supply from overloads.
The maximum setting value and the adjust-
ment values may vary from country to coun-
try.
The preset default value is the minimum set-
ting. This is the minimum charge current
available from the mains supply.
If the charging cable is left connected to the
mains socket, the currently selected values
will be used for the next charging process. If
the charging cable is removed from the
mains socket, the values will be reset to the
minimum setting for the next charging proc-
ess.
X
Check the maximum permissible charge
current for the relevant mains socket.
X
Insert the mains plug into the mains
socket.
You have one minute to set the charge cur-
rent.
X
Press button A repeatedly until the indi-
cator lamp in the desired setting lights up
green.
The desired value has been set.
i
After one minute, the charge current can
only be set by restarting. To do so, remove
the charging cable from the mains supply
and reinsert it into the mains socket.