User Interface Alarm - Quadra-Fire TREKKER Series Owner's Manual

C. User Interface Alarm
Following correction of any alarm, the user interface will turn to OFF. Turn user interface back ON and back to desired setting.
ALARM
Hopper empty
Auger jam
Vacuum switch not closing
Hopper lid open
Feed Error
Exhaust probe does not sense temperature
Snap disc tripped
Exhaust probe not attached to exhaust
blower properly
Exhaust path is dirty
Hopper empty
Feed motor doesn't turn
Ignition Error
Dirty appliance
Igniter has no power or is defective
Exhaust probe not properly installed
Igniter chamber plugged with debris
Not connected to the control board
2 Exhaust Probe Fail
Failed component
Wire from exhaust blower or encoder is
disconnected or shorted
6 Exhaust
Defective exhaust blower
Blower Alarm
Defective encoder (on end of exhaust
blower)
Feed Motor Locked On
8 Exhaust Over-Temp Non-approved fuel used
Convection blower dirty
Bluetooth Key does not have power (blue
light on key is not on)
10
Communication Error
Bluetooth Key and user interface not paired
User interface experiencing
communication interruption
Table 24.1
24
POSSIBLE CAUSE
7080-166J
CORRECTIVE ACTION
Fill the hopper
Inspect the feed tube for jams
Make sure firebox door is shut, vacuum hose is connected to
switch and drop tube, wire connectors are connected to vacuum
switch, control board, hopper switch, and safety snap disc.
Close the hopper lid
Secure the exhaust probe keeping its wire away from hot
surfaces and clean the exhaust plenum
Reset snap disc
Secure exhaust probe to exhaust blower housing – keeping its
wire away from hot surfaces
Clean unit including the fire pot, exhaust path, and
venting system
Fill the hopper
Inspect feed motor circuit (hopper lid must be closed, vacuum
switch must be closed, snap disc closed, and feed motor must
be plugged in)
Clear jam in feed tube
Clean unit including the fire pot, exhaust path, and
venting system
Check igniter lead connections or replace igniter
Secure exhaust probe to exhaust blower housing – keeping its
wire away from hot surfaces
Clean igniter chamber
Connect terminal end to control board
Replace exhaust probe – securing it to exhaust blower housing
– keeping wire away from hot surfaces
Make sure wire is not damaged / melted and ends are fully
connected to the encoder and control board.
Replace exhaust blower
Replace exhaust blower
Repair wire(s) and replace control board
Only use wood pellet fuel. Do not enhance its performance with
any other combustible substance.
Clean impellers
Plug appliance into power source
USB extension cable not plugged in
Bluetooth key not plugged in.
Replace Bluetooth Key
Replace USB extension cable not plugged in
Replace control board
Pair Bluetooth Key and user interface
Move user interface closer to the Bluetooth Key or to another
location (within 30 feet)
Remove any obstructions between user interface and
Bluetooth Key
March 17, 2020