User Interface Display - Quadra-Fire TREKKER Series Owner's Manual

SYMPTOM
Large, lazy flame
(orange color) with
black ash / soot buildup
on glass
Excessive fuel spilling
over the fire pot and/or
excessive flame
Black soot on the side of
the house
Unit rumbles consistently
during burns
Table 23.1
B. User Interface Display
ISSUE
Ghosting on Display
Frozen Screen (No change
with input)
Screen off center
Blank / Black Screen / No
Screen Change
Lines Through Screen /
Partial Display
Table 23.2
March 17, 2020
POSSIBLE CAUSE
Dirty appliance or venting
Poor fuel quality, high ash content.
Incorrect air-fuel adjustment
Excessive feeding
Feed Motor locked on
Dirty Appliance
Feed Motor locked on
Dirty Appliance
Exhaust termination cap too close to
the structure
Excessive feeding (incorrect air-
fuel ratio)
Too much fuel
Too much air
NOTE: Refer to Tuning section for more information,
POSSIBLE CAUSE
Low battery
Bad battery connection
Dead or low battery
Bad refresh
Failed Boot
Bad or Damaged screen
CORRECTIVE ACTION
Clean unit including the fire pot, exhaust path, and venting system
Purge old fuel and use higher quality / or brand of fuel
Adjust the trim (see trim adjustment section)
Adjust tuning per tuning instructions
Follow corrective action for feed motor not turning off
Clean unit including the fire pot, exhaust path, and venting system
Follow corrective action for feed motor not turning off
Clean unit including the fire pot, exhaust path, and venting system
Extend the termination further from the structure
Adjust the tuning (see tuning section)
Turn tuning down one number at a time
Turn tuning setting to one; one number at a time
page 12.
Enter and exit menu to refresh screen (If refresh does not
fix the issue, replace batteries).
Either replace batteries, or remove and re-install the
batteries to refresh the screen.
Either enter and exit the menu or remove and re-install or
replace the batteries to refresh the screen.
Re-boot user interface by removing the batteries, waiting
15 seconds and re-installing the batteries.
Refresh screen by entering and exiting the menu (If not
fixed, replace user interface).
7080-166J
CORRECTIVE ACTION
23