Cisco ASR 1002-X Overview And Installation page 35

Cisco ASR 1002-X Router Overview and Installation
4.
5.
6.
7.
8.
9.
10.
DETAILED STEPS
Step 1 At the rear of the router, check that the power supply Standby switch is in the Standby (see
1002-X Router –48 VDC Power Supply Terminal Block Cable Connections, on page 35
Figure 24: Cisco ASR 1002-X Router –48 VDC Power Supply Terminal Block Cable Connections
1 Ground lead with service loop and tie wrap
2 Positive lead
Step 2
Ensure that the negative and positive leads are disconnected from the site power source.
Insert the stripped end of the ground lead all the way into the ground lead receptacle on the –48 VDC
input power supply, and tighten the receptacle screw using a 3.5 mm flat-blade screwdriver to a torque
of 0.5 to 0.6 Nm.
Insert the stripped end of the positive lead all the way into the positive lead receptacle and tighten the
receptacle screw using the same 3.5mm flat-blade screwdriver.
Repeat this step for the negative lead.
After tightening the receptacle screw for the ground, positive, and negative –48 VDC-input leads, use
a cable tie to secure the three leads to the power supply faceplate, as shown in
1002-X Router –48 VDC Power Supply Terminal Block Cable Connections, on page
the ground, positive, and negative –48 VDC-input leads to the power supply faceplate, leave a small
service loop in the ground lead to ensure that the ground lead is the last lead to disconnect from the
power supply if a great deal of strain is placed on all three leads, as shown in
1002-X Router –48 VDC Power Supply Terminal Block Cable Connections, on page
Connect the ground, positive, and negative leads to the power source.
Turn the branch source breaker on.
Place the –48 VDC Standby switch in the On (|) position. The power supply LEDs light when power
is supplied to the router.
Connecting the –48 VDC Input Power to the Cisco ASR 1002-X Router
3 Negative lead
4 –48 VDC power supply Standby switch
Cisco ASR 1002-X Router Overview and Installation
Figure 24: Cisco ASR
35. When securing
Figure 24: Cisco ASR
35.
Figure 24: Cisco ASR
) position.
35