Cisco ASR 1002-X Overview And Installation page 25

Cisco ASR 1002-X Router Overview and Installation
The cable management brackets for the Cisco ASR 1002-X Router contain an independent cable management
U type feature with four screws and provides cable dressing for each card module slot.
Note
Ensure that the cable management bracket U type feature is facing upwards when you attach it to the chassis.
Follow these steps to attach the cable management brackets to both sides of the Cisco ASR 1002-X Router
in the rack:
SUMMARY STEPS
1. Align the cable management bracket to the rack mount bracket on one side of the Cisco ASR 1002-X
Router. The cable management bracket aligns to the top hole of the chassis rack mount bracket.
2. Using a Phillips screwdriver, insert the screw through cable management bracket and into the chassis rack
mount and tighten the screw. Use the package of four screws shipped with the router.
3. Using the bottom rack mount ear hole, insert the screw through cable management bracket and into the
chassis rack mount (see
Brackets, on page
DETAILED STEPS
Step 1 Align the cable management bracket to the rack mount bracket on one side of the Cisco ASR 1002-X Router. The cable
management bracket aligns to the top hole of the chassis rack mount bracket.
Step 2 Using a Phillips screwdriver, insert the screw through cable management bracket and into the chassis rack mount and
tighten the screw. Use the package of four screws shipped with the router.
The following imave shows the locations at which to attach the front rack mount brackets to the Cisco ASR 1002-X
Router in a rack.
Figure 15: Chassis Rack Mount Bracket Ear Holes for the Cable Management Brackets
1 Secure the cable management top screw and bottom to this ear hole
2 Cable-management bracket
Figure 15: Chassis Rack Mount Bracket Ear Holes for the Cable Management
25).
Attaching the Cable Management Bracket
3 Front rack mount bracket
—
Cisco ASR 1002-X Router Overview and Installation
25