Advertisement
3. 3. 3. 3.
Installing the new tape drive—
a. a. a. a.
Library connectors—Locate the serial cable (
appropriate serial connector inside the library (see
Full height tape drive—see
Half height tape drive—see
Tape drive
Full height
Single tape drive
Second tape drive
Half height
Single tape drive
b. b. b. b.
While holding the cables out of the way, slide the new tape drive into the library, leaving it a short distance
out to access the cables. Use care not to damage the cables.
c. c. c. c.
Tape drive connectors—Connect the supplied serial cable (
Full Height tape drive cable connections—
Serial—Route the serial cable (
Power—Route the power cable (
page
4.
Half Height tape drive cable connections—
Serial—Route the serial cable (
6) and connect as shown in
Power—Route the power cable (
page
4.
d. d. d. d.
Slide the tape drive the remaining distance into the library. Use care not to damage the cables during this
step.
4. 4. 4. 4.
Completing the installation—
a. a. a. a.
Attach the SCSI cover plate and the tape drive cover plate that came with your replacement kit. See
Drive Cover Plates and Serial Cable" on page
! Important
b. b. b. b.
Reconfigure your library—You must reconfigure your library for your backup application to recognize
the new tape drive. See
8
12
OF
Figure 2 on page 4
Figure 3 on page 4
Quantity
Install in this opening...
) under the tape drive carrier and connect as shown in
S
) through the tape drive carriers and connect as shown in
P
) over the tape drive carrier and under the power cable (see
S
Figure 3 on page
) through the tape drive carriers and connect as shown in
P
The library requires both the SCSI cover plates and the tape drive cover plates for
ESD protection. Do not leave any openings uncovered.
Do not connect the SCSI cables until after you reconfigure the library.
page 10
for instructions.
) that came in your replacement kit and attach it to the
S
Figure 1 on page
Serial connector
Bottom
Top
Bottom
) and the power cable (
S
4.
3.
3).
Internal label
Bottom
Drive 1
Top
Drive 2
Bottom
Drive 1
) to the tape drives.
P
Figure 2 on page
Figure 8 on page
4.
Figure 4 on
Figure 5 on
"Tape
Advertisement
