Advertisement
I
A
NSTALLING
DDITIONAL
To install an additional tape drive, follow these steps:
1. 1. 1. 1.
Preparing for replacement—
a. a. a. a.
Power off the host.
b. b. b. b.
Power off the library (press the 0 on the back of the unit).
c. c. c. c.
Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the terminator (if one is installed).
d. d. d. d.
Remove the tape drive cover plate. Set the plate and the screws aside.
Back of library
Figure 6
Tape drive cover plate (HH SCSI library)
Note:
This figure shows the SCSI library. Remove the Fibre Channel tape drive cover plate the same way.
2. 2. 2. 2.
Removing the internal cooling plates and disconnecting cables—
a. a. a. a.
Remove the two screws (
the screws.
Figure 7
Tape drive cooling plate
b. b. b. b.
Disconnect all of the power cables (
3. 3. 3. 3.
Installing the tape drive—
T
D
APE
RIVES
Screws (2 each side)
) holding the tape drive cooling plate (
A
).
P
). Remove the plate, and discard it and
B
Cooling plate
(B)
Screws (A)
Looking inside back of library
Tape drive
cover plate
Power OFF
(press the 0)
Disconnect
power cord
5
12
OF
Advertisement
