Advertisement
Serial—Route the serial cable (
Power—Route the power cable (
page
4.
d. d. d. d.
Slide the tape drive the remaining distance into the library.
4. 4. 4. 4.
Completing the installation—
a. a. a. a.
Attach the SCSI cover plates and the tape drive cover plate that came with your replacement kit. See
Drive Cover Plates and Serial Cable" on page
! Important
b. b. b. b.
Reconfigure your library—You must reconfigure your library for your backup application to recognize
the new tape drive. See
R
ECONFIGURING THE
R
ECONFIGURING THE
In order for the library to recognize the new tape drive, you must set the tape drive configuration to match the
tape drives that you installed in the library.
Note:
Do not connect the SCSI cables at this time.
To set tape drive configuration:
1. 1. 1. 1.
At the Home screen, press Drive.
If necessary, enter the operator panel password (see the Product Manual at www.tandbergdata.com).
2. 2. 2. 2.
Press
until the selection arrow (
Drive
Drive ID
Interface
Drive Configuration
Library SCSI Bridge
10
12
OF
) under the tape drive carrier and connect as shown in
S
) through the tape drive carriers and connect as shown in
P
The library requires both the SCSI cover plates and the tape drive cover plates for
ESD protection. Do not leave any openings uncovered.
Do not connect the SCSI cables until after you reconfigure the library.
page 10
(below) for instructions.
L
IBRARY AND
L
IBRARY
) points to Drive Configuration, press Select, and then press Modify.
Select
3.
R
O
ESUMING
PERATION
Drive Configuration
1:
IBM LTO FullHigh
2:
no drive
Back
Figure 2 on page
Figure 4 on
Modify
OK
4.
"Tape
Advertisement
