Advertisement
a. a. a. a.
Library connectors—Locate the serial cable (
appropriate serial connector inside the library (see
Tape drive
Half height
b. b. b. b.
While holding the cables to the side, slide the new tape drive directly into the library, leaving it a short
distance out to access the cables. Use care not to damage the cables.
c. c. c. c.
Tape drive connectors—Connect the supplied serial cable (
Serial—Route the serial cable (
connect as shown in
Power—Route the power cable (
Figure 5 on page
Press the serial cable (S) down into the carrier to prevent
catching it between the tape drive and the library.
Figure 8
Installing additional tape drives: half height connectors
d. d. d. d.
Slide the tape drive the remaining distance into the library. Install the tape drives from bottom to top—fill
the bottom slot first, the second slot next, and so forth.
4. 4. 4. 4.
Completing the installation—
a. a. a. a.
Locate the tape drive cover plate (see
the necessary SCSI plates, then attach the tape drive cover plate with the screws you removed earlier.
! Important
6
12
OF
Quantity
Install in this opening...
Second tape drive
Single tape drive
) over the tape drive carrier and under the power cable as shown here;
S
Figure 3 on page
) through the tape drive carriers as shown here; and connect as shown in
P
4.
"Tape Drive Cover Plates and Serial Cable" on page
The library requires both the SCSI cover plates and the tape drive cover plates for
ESD protection. Do not leave any openings uncovered.
Do not connect the SCSI cables until after you reconfigure the library.
) that came in your replacement kit and attach it to the
S
Figure 1 on page 3
Top
Bottom
S
4.
and
Figure 3 on page
Serial connector
Top
Bottom
) and the power cable (
Power cable
(route under carrier and
over serial cable)
Serial cable
(route over carrier and
under the power cable)
Tape drive carrier
4).
Internal label
Drive 2
Drive 1
) to the tape drives.
P
(P)
(S)
3). First, remove
Advertisement
