Preparation And Quick Start; Introduction; Set Up The Network; Transmitter Quick Start - Honeywell SmartLine STIW400 User Manual

2.1

Introduction

This section is useful if you are unfamiliar with the SmartLine Wireless transmitter, want a quick
start list, or if you want to configure and test your transmitter in an office environment before
installing it in its final location.
2.2

Set up the Network

Refer to the One Wireless Device Manager User Guide and Field Device Access Point User
Guide to setup the gateway, wireless device manager (WDM) and the access points (FDAP).
See References.
2.3

Transmitter Quick Start

1. INSTALL. If desired, mount or install the transmitter. If setting up in an office environment
for test, place the transmitter securely on a work surface.
2. ANTENNA. The transmitter can be supplied with an integral 4dBi antenna. If the transmitter
is equipped with a remote mount antenna connection, connect the antenna with a RF cable.
The transmitter remote mount and antennas utilize N-type connectors.
3. POWER up the transmitter.
Remove the end cap, opposite the LCD display, to connect power. Ensure the internal power
cable is connected to the battery pack or 24V supply module as applicable.
a. Battery Operated transmitters require two 3.6 V D-Size lithium thionyl chloride
b. Line powered transmitters with the power supply option require 24V DC connected
Once powered, verify that the transmitter LCD is functioning. If the LCD is blank, check the
power connections, and batteries as applicable.
4. PROVISION the transmitter to the network
a. Over The Air (OTA) provisioning can be done using the WDM interface.
b. Handheld provisioning can be done through the IR port with a Handheld Provisioning
Device such as MCT404
See section
depending on your network.
Revision 1

2. Preparation and Quick Start

Ensure you have access to the WDM through the browser interface.
batteries. See section 5.1
to the input connector P3. See section
i. Enable OTA provisioning on the access point closest to the transmitter.
On the WDM interface, select the access point, then on the property panel
expand and "Device Management" and under Over the Air Provisioning
press "Enable for 60 Minutes"
ii. Select the transmitter in the selection panel
iii. Press the provisioning green "Accept" check mark button
5.5 for further provisioning details. This step may take several minutes,
SmartLine Wireless Temperature and Universal I/O User's Manual
for specific battery requirements.
5.2 for details.
2. Preparation and Quick Start
2.1. Introduction
7