Vision Fitness Deluxe TC17305 Calibration Manual

T 9 5 0 0
( TM 1 8 1)
C a l i b r at i on G u id e
STEP 1 EnTEr EnginEEring ModE
• W ith the SAFETY KEY in place, hold the
dOwN" buttons for 5 seconds. The profile window will read "DGA3J"
and the function window will read "NONE".
• U se the elevation keys until "ENG1" is displayed in the function window.
Press "sELECT" . You are now in ENGINEERING MODE.
STEP 2 SET MiniMuM SPEEd
• P ress the "ELEVATION dOwN"
"P0". "0" will appear in the elevation window and "39" should appear in
the speed window. To adjust, press
• P ress the
"sPEEd UP"
window reads "35 - 41". The running belt should be moving at .5 MPH.
• Press the "sELECT" button to update the data.
STEP 3 SET MaxiMuM SPEEd
• P ress the "ELEVATION UP"
"0" will appear in the elevation window and "418" should appear in the
speed window. To adjust, press
• P ress the "sPEEd UP" or
dow reads "415 - 425". The running belt should be moving at 12 MPH.
• Press the "sELECT" button to update the data.
STEP 4 SET ThE half MaxiMuM SPEEd
• P ress the
"ELEVATION UP"
"0" will appear in the elevation window and "216" should appear in the
speed window. To adjust, press
• P ress the "sPEEd UP"
reads "210 - 220". The running belt should be moving at 6 MPH.
• Press the button to update the data.
"sELECT"
Date of last revision: 9.05
D e l u xe
"ELEVATION UP"
button until the function window reads
"sTART" .
or button until the elevation
"sPEEd dOwN"
button until the function window reads "P1".
"sTART" .
"sPEEd dOwN" button until the elevation win-
button until the function window reads "P2".
.
"sTART"
or "sPEEd dOwN" buttons until the console
( T C1 7 3 0 5 )
and
"sPEEd
1
TREADMILL.CALIB.TM181.TC17305.REV1