Cisco ASR 914 Manual page 44

Patch Panel Cabling for Redundancy
The following table shows details of the patch panel cables:
Patch Panel Cable
CABLE-16TDM-C
CABLE-16TDM-C-L1
CABLE-16TDM-C-L2
CABLE-16TDM-C-L3
CABLE-16TDM-C-L4
Patch Panel Cabling for Redundancy
You can connect the patch panels with the interface modules for redundancy, using the Y-cables. The Y-cable
stub lengths are reduced, so that the cable does not exceed from the rack spacer. The Y-cables are numbered
based on the different stub length. Cable lengths differ for even numbered and odd numbered slots in the
chassis.
Installing the Cisco ASR 914 Router
44
Description
16-port cable for TDM CEM Interface Module, no redundancy, 6 feet in length
16-port cable for TDM CEM Interface Module, no redundancy, 4.7 feet in length
16-port cable for TDM CEM Interface Module, no redundancy, 5.3 feet in length
16-port cable for TDM CEM Interface Module, no redundancy, 7.1 feet in length
16-port cable for TDM CEM Interface Module, no redundancy, 8 feet in length
Installing the Cisco ASR 914 Router