Cisco ASR 914 Manual page 29

Hide thumbs Also See for ASR 914:

Table of Contents

Installing the Cisco ASR 914 Router

Perform the following procedure to install the power feeds.

Note

Ensure that power to DC circuit connected to the power supply you are about to install is switched off. To

verify, locate the circuit breakers for the DC circuits, put the circuit breakers to the OFF position, and tape

the circuit-breaker switches.

Note

Replace the fan tray only when both fan power feeds are active; violation may result in immediate shut down

of the entire system.

Procedure

Step 1

Verify that the correct fuse and alarm panel are installed.

Step 2

Connect each distribution cable according to the fuse panel engineering specifications.

Step 3

Measure and cut the cables as required to reach the router from the fuse panel.

Step 4

Strip 1/2 inch (12.7 mm) of insulation from all power cables that you use.

Step 5

Crimp the lugs onto the ends of all the power distribution cables using the manufacturer's suggested die for

the lug.

Step 6

Remove the terminal block protective covers from the power distribution lugs.

Figure 16: Connecting DC Power Feeds

Installing DC Power Feeds for Fan Tray

Installing the Cisco ASR 914 Router

Table of Contents