Aquasystem® (Aqs) - Jacuzzi J.Touch Use & Maintenance

Aquasystem®
programme
activation
If the remote control
fails to activate or where the smallest
LED light flashes, the battery must be
charged (refer to the Chapter.
ing the J.touch remote control")
Once on, the J.touch remote control,
where not used, switches off after
about 15 seconds; to turn it on again,
lightly shake it
You must wait a few seconds before
the pump starts, until the initial check
procedures are completed
The pump(s) is activated at maximum
intensity; after a few seconds, it will
assume the characteristic value of the
programme selected
the programmes
With models equipped with two
pumps, the programme is the same
for both
(AQS)
Fill the tub, turn on the main switch and hold down the key displayed until the function keys
come on (the battery charge level is briefly presented).
1
"Charg-
Hold down the key controlling the pump start-up: after a few seconds, the function will
begin (the "silence" programme will be activated).
With models equipped with two pumps, the pumps are activated simultaneously; (it is
also possible to exclude one - but not both - by holding down the relative key).
selecting
To select a different programme than the one offered, press, in sequence, the "AQS" key
(you must wait a few seconds before the new programme begins).
S
imply press the J.touch remote control keys to select from
the four different hydromassage programmes available:
- Silence
- Breath
- Dream
- Renew
Naturally, each programme is personalised to satisfy tastes.
1 2
2
1 2
1 2
33
;
;
;
;
1
Silence
1
Renew
4
1 2
2
Dream
2
Breath
3