Classic Hydromassage - Jacuzzi J.Touch Use & Maintenance

Classic
hydromassage
programme
activation
If the remote control
fails to activate or where the smallest
LED light flashes, the battery must be
charged (refer to the Chapter.
ing the J.touch remote control")
Once on, the J.touch remote control,
where not used, switches off after
about 15 seconds; to turn it on again,
lightly shake it
You must wait a few seconds before
the pump starts, until the initial check
procedures are completed
The pumps are activated at pre-set in-
tensity levels; these can be adjusted, a
few seconds after switching on as de-
scribed below
varying the
hydromassage intensity
It is possible to adjust the intensity ac-
cording to five levels, divided as follows:
0 - 1
2 - 3
4 - 5
Fill the tub, turn on the main switch and hold down the key displayed until the function
keys come on (the battery charge level is briefly presented).
1
"Charg-
Keep the "pump1" (or "pump2" ) key held down to activate the respective pump.
With models equipped with two pumps, the pumps can be activated individually or
simultaneously; it is also possible to exclude one (but not both) by holding down the rel-
ative key.
AQS mod.
It is possible to use just one or both pumps: keep the key of the pump you wish to ad-
just held down and repeatedly press the "-" or "+" keys (once adjustments have been made,
the pump-key LED light will light up and briefly flash).
In the instance where just one pump is active, adjustment may be completed without
pressing the relative key beforehand.
P
atented original well-being. The timeless Jacuzzi® hy-
dromassage technology uses adjustable jets, used in all
directions, which massage, stimulate and tone the entire
body extending to the legs right to the bottom of feet. Pro-
gressively gaining intensity, in a central direction, and which
involves all muscle parts, unwinding, energising and ulti-
mately relaxing the body.
1 2
2
pump 1
1 2
1 2
31
1
pump 2
1 2
1 2
2