Appendix 2: Remote Communications; Approved Modems; Modem Or Isdn Terminal Adapter Connection; Modem Requirements - Honeywell Excel 800 SYSTEM Installation And Commissioning Instructions

Excel 800

Appendix 2: Remote Communications

For remote communications with up to three centrals, a
modem or ISDN terminal adapter can be connected directly
to the modem interface of the XCL8010 Controller Module.
Notes
Remote communication via modem or ISDN terminal
adapter requires firmware version V2.1.0 or higher.
XBSi building supervisors are not supported for remote
communication.

Approved Modems

For information on modems approved for use with the Excel
800, please refer to the "Frequently Asked Questions and
Troubleshooting" document available via the Honeywell
Technical Assistance Center (TAC) or, for Honeywell
employees, on the Intranet under:
http://web.ge51.honeywell.de/tac
Go there, and enter the catchword "modemfaq" in the
►
search field.
Modem or ISDN Terminal Adapter
Connection
The modem interface of the XCL8010 Controller Module
accepts a standard modem cable with a female 9-pin
connector.
Fig. 114 Modem interface
Connect the cable that is supplied with the modem/ISDN
►
terminal adapter to the modem interface of the XCL8010
Controller.

Modem Requirements

A "Frequently Asked Questions and Troubleshooting"
document is available via the Honeywell Technical
Assistance Center (TAC) or, for Honeywell employees, on
the Intranet under:
http://web.ge51.honeywell.de/tac
Go there, and enter the catchword "modemfaq" in the
►
search field.

Troubleshooting

In case of any problems, the handbook of the modem or
ISDN terminal adapter must be consulted.
A "Frequently Asked Questions and Troubleshooting"
document is available via the Honeywell Technical
Assistance Center (TAC) or, for Honeywell employees, on
the Intranet under:
http://web.ge51.honeywell.de/tac
Go there, and enter the catchword "modemfaq" in the
►
search field.
83
Appendix 2: Remote Communications
EN1B-0375GE51 R0910