Setting Address Of Panel Bus I/O Modules; Setting I/O Bus Switch - Honeywell Excel 800 SYSTEM Installation And Commissioning Instructions

Wiring and Setting Up the System

Setting Address of Panel Bus I/O Modules

During CARE engineering, each Panel Bus I/O module is
assigned its own unique address. For the sake of clarity for
maintenance personnel, it is recommended that you
address the Panel Bus I/O modules in ascending order
0 through F.
Hex switch 0 1
Address 01 02
Hex switch 8 9
Address 09 10
Table 24 HEX switch settings and addresses
Use the rotary HEX switch to set the address to the one
►
already defined during CARE engineering.
LOCK
Fig. 38 HEX switch location
Notes
 If the HEX switch is changed, the Panel Bus I/O module
will revert to its default configuration.
 With L
W Bus I/O modules, the HEX switch is
ON ORKS
without function.
EN1B-0375GE51 R0910
2 3 4 5 6
03 04 05 06 07
A B C D E
11 12 13 14 15
4
4

Setting I/O Bus Switch

Set the I/O Bus switch S2 of the XCL8010 Controller
►
Module depending on the modules connected to
terminals 71 ... 78 and the desired communication as
follows:
Communication
7
L W Bus
ON ORKS
08 only
F
Panel Bus and
L W Bus
ON ORKS
16
Table 25 I/O Bus switch settings
Fig. 39 S2 I/O Bus switch
28
S2 setting Terminals
LON 71 ... 74 L
ON
75 ... 78 L
ON
11 ... 14 L
ON
Panel 71 ... 74 Panel Bus
75 ... 78 Panel Bus
11 ... 14 L
ON
Excel 800
W Bus
ORKS
W Bus
ORKS
W Bus
ORKS
W Bus
ORKS