Esc+#E Print Darkness - SATO WS4 Series Programming Reference Manual

System
Available for
WS4 series

ESC+#E Print Darkness

Print Darkness
ESC
Hex code
<1B>
16
Default setting See table below
When printer is powered off
Persistence of
Validity in a job
the command
Validity after a job
[Function]
Specifies print darkness.
[Format]
<#E>a(b)
●Parameter
a [Darkness level]
b [Darkness range]
[Coding Example]
<A>
<#E>3
<Z>
[Note]
1. The setting by this command will not persist after powering off the printer. When the printer restarted, either the printer' default
value, or original values set by the command <PG> will be valid.
[Tips]
1. Invalid range being selected will result in a command error and the setting will not be changed.
2. The default values are available by the operation of the printer side.
[Default value and valid range]
Model Parameter
WS408DT/TT a
WS412DT/TT
b
#E Parameter
<23> <45> a(b)
16 16
Set parameter will not be retained
Retained until next valid setting
Retained until next valid setting
= See table below.
= A (Omissible)
Use [A] for darkness range under normal conditions
Default Range
3 : Normal 1: Light
2: Slightly light
3: Normal
4: Slightly dark
5: Dark
A A
ESC+#E
172