Method For Updating The Instruction Manual; Recipients; Glossary And Pictograms - Wega MyConcept EVDP 2GR Use And Maintenance Manual

Method for updating the Instruction
1.3
Manual
The Manufacturer reserves the right to modify and
make improvements to the machine without notifying
it and without updating the Manual already delivered.
Moreover, in case of substantial changes to the al-
ready installed machine involving the modification of
one or more chapters of the Instruction Manual, the
Manufacturer will send the Qualified Technicians the
chapters affected by the changes or the revision of the
entire manual.
It is the Qualified Technicians' responsibility, to re-
place the old document with the new revision.
The manufacturer is responsible for the Italian
descriptions; the translations cannot be fully verified;
therefore, in case of inconsistency, users must pay at-
tention to the Italian version and possibly contact the
Manufacturer, who will make the appropriate changes.
If the manual should become illegible or otherwise hard to consult,
the Qualified Technicians is obliged to request a new copy from
the Manufacturer before carrying out any work on the machine.
It is absolutely forbidden to remove or rewrite parts of the Manual.
The instructions, drawings and documentation contained in this
manual are confidential and the sole property of the Manufacturer,
and may not be reproduced in any way, either in full, or in part
without prior authorization.
Qualified Technicians are responsible for the compliance with the
instructions contained in this Manual.
For any incident that should occur as a result of incorrect use of
these recommendations, the Manufacturer declines any liability.

Recipients

1.4
This Manual is intended for the Manufacturer's Quali-
fied Technicians, to whom the following operations per-
taining to the machine are assigned:
• Transport and handling;
• Storage;
• Installation;
• Commissioning;
• Maintenance;
• Cleaning;
• Spare part replacement;
• Emergency operations and faults;
• Decommissioning;
• Dismantling;
• Disposal;
TECHNICIANS manual
QUALIFICATION OF RECIPIENTS
The machine is intended for professional and not
generalized use, so it can be used by Qualified Techni-
cians, in particular who:
• Have attended the training courses organized by the
Manufacturer relating to the type of machine;
• Have reached the age of majority;
• Are physically and mentally fit for using the machine;
• Are able to understand and interpret the Instruction
Manual and the safety requirements;
• Know the safety procedures and their implementa-
tion;
• Possess the ability to use of the machine;
• Understand the procedures of use defined by the
machine manufacturer.

Glossary and Pictograms

1.5
This paragraph lists uncommon terms or terms with
different meaning from the ordinary.
Below is an explanation of the abbreviations used and
the meaning of the pictograms to indicate the operator
qualification and the machine status; their use allows to
quickly and uniquely provide the necessary information
for proper use of the machine in safe conditions.
1.5.1 GLOSSARY
User
The person in charge of the periodic maintenance and
cleaning of the machine indicated in the User's Manual.
Manufacturer's Qualified Technician
A specialist, specially trained and qualified to make
the connection, installation and assembly of the ma-
chine; use special equipment (hoists, forklifts, etc.);
perform routine or unscheduled maintenance which
is particularly complicated or potentially dangerous if
performed by the User.
Qualification of the User or Qualified Technician
Minimum level of skills an operator must have to carry
out the operation described.
Danger
A potential source of injury or damage to health.
Dangerous area
Any area in the vicinity of the machine where the
presence of a person constitutes a risk to the safety and
health of that person.
Risk
Combination of the probability and severity of an
injury or damage to health that can arise in a hazardous
situation.
5 76
of