TP-Link TD-W8960N User Manual page 72

4.5.2.2 Manual Setup AP
Follow the instructions below to configure security features of the wireless LAN interface manually.
You can set the network authentication method, select data encryption, specify whether a network
key is required to authenticate to this wireless network and specify the encryption strength.
Network Authentication: Select an authentication type from the drop-down list. Options
available are: Open, Shared, WPA, WPA-PSK, WPA2, WPA2-PSK, Mixed WPA2/WPA, and
Mixed WPA2/WPA-PSK.
Note:
For most users, it is recommended to use the default Wireless LAN Performance settings. Any
changes made to these settings may adversely affect your wireless network. Under certain
circumstances, changes may benefit performance. Carefully consider and evaluate any changes
to these wireless settings.
1. WEP
WEP is a basic encryption method offering two levels of encryption, 64-bit and 128-bit encryption.
If you select enable from the drop-down list of WEP Encryption, you will see the screen shown as
below.
TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-76
Figure 4-77
65