Eth-Ipoe; Eth-Bridge; Lan - TP-Link TD-W8960N User Manual

4.4.2.7 ETH-IPoE

If your ISP provides an IPoE connection and you want to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to IPoE
over ATM interface (see section
set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding
screen see Figure 4-10).

4.4.2.8 ETH-Bridge

If you want to adopt the Bridge service and you need to use an ETH Interface, follow the steps
below to add a WAN service over a selected ETH interface:
1. Add a new ETH interface on the screen of
2. Click the Add button on the screen Figure 4-8 and the next configuration is similar to Bridge
over ATM interface (see section
set the 802.1P Priority and 802.1Q VLAN ID on the screen of Figure 4-20 (corresponding
screen see Figure 4-10).
Note:
The Bridge option only display on the screen of Figure 4-20 when VLAN MUX Mode is selected for
Connection Mode on the screen of Figure 4-6.

4.4.3 LAN

Choose "Advanced Setup" "LAN", and you will see the LAN screen (shown in Figure 4-21), the
section allows you to configure the Router's LAN ports settings.
TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-20
4.4.2.2 ATM-EoA-IPoE). The difference is that you have to
4.4.2.3 ATM-EoA-Bridge). The difference is that you have to
4.4.1.2 ETH interfaces.
4.4.1.2 ETH interfaces.
28