TP-Link TD-W8960N User Manual page 28

PPP Username/Password: Enter the User Name and Password provided by your ISP.
These fields are case-sensitive.
PPPoE Service Name: Enter the Service Name if it was provided by your ISP. If you leave it
blank, the default name will be the same as the service Description on the previous screen.
Authentication Method: Select the Authentication Method in the drop-down list, the default
method is AUTO, and you can leave it as a default setting.
Note:
If you are not sure about the PPP IP extension and PPP Debug Mode etc. below, please don't
select these options.
Enable Fullcone NAT: It is a type of NAT, if not enabled, the default NAT will act.
Dial on demand (with idle timeout timer): The Router will cut off the Internet connection after
it has been inactive for a specific period of time (idle timeout), and it will automatically
re-establish the connection as soon as you attempt to access the Internet again. If your
Internet is charged by time you may want to select this option in order to save money.
PPP IP extension: Select this option to get the public IP address from the PPP server to your
PC, and the NAT and SPI Firewall will be closed. Sometimes you can think it as bridge while
PPP dialing in the router. It's a special feature deployed by some ISP. Unless your ISP
specifically requires this setup, do not select it.
Use Static IPv4 Address: If your ISP gives you a static WAN, Gateway and DNS IP address,
select this option to enter them manually.
Enable PPP Debug Mode: Select this option to debug the PPP function and you can see
many PPP log information in the System Log. Only PPP has this debug Mode.
Bridge PPPoE Frames Between WAN and Local Ports: Select this option to start PPP
connection in your local PC.
TD-W8960N Wireless N ADSL2+ Modem Router User Guide
Figure 4-11
21