Install Faucet - American Standard DXV Percy D35105.104 Installation Instructions Manual

1

INSTALL FAUCET

• Seat O-RING SEAL (1) into under side of FAUCET BASE (2).
• Feed FAUCET SUPPLIES (3), MOUNTING STUD (4) and DRAIN CABLE ASSEMBLY (8) through the mounting hole of lavatory
or mounting surface. Fig. A.
• From below, push GASKET (7) and RETAINING WASHER (5) onto MOUNTING STUD (4). Secure Faucet with MOUNTING
NUT (6), pulling faucet to front of sink, so SUPPLIES (3)
on MOUNTING NUT (6) is seated into RETAINING WASHER (5). Fig. B.
• Adjust Faucet so that it is centered. Tighten MOUNTING NUT (6) to complete faucet mounting.
Fig. B.
COLLAR ON
MOUNTING NUT
CAUTION
Turn off hot and cold water supplies before beginning.
7
5
6
4
Fig. A.
2
GROOVE
(FAUCET BASE)
4
MOUNTING SURFACE
8
- 2 -
1
3
M9 65530 Re v. 1.2