INSTALLATION
INSTRUCTIONS
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this product
is installed properly, please read these instructions carefully before you begin. (Certain installations may require
professional help.) Also be sure your installation conforms to local codes.
!
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND POSSIBLE INJURY HANDLE WITH CARE!
NOTE: Pictures may not exactly define contour of china and components.
RECOMMENDED TOOLS AND MATERIALS
Putty Knife
Regular Screwdriver
Hacksaw
Wax Ring/Gasket
1
REMOVE OLD TOILET
a.
Close toilet supply valve and flush tank completely. Towel or sponge remaining water from tank and bowl.
b.
Disconnect and remove supply line. NOTE: If replacing valve, first shut off main water supply!
c.
Remove old mounting hardware, remove toilet and plug floor waste opening to prevent escaping sewer gases.
d.
Remove closet bolts from flange and clean away old wax, putty, etc. from base area.
NOTE: Mounting surface must be clean and level before new toilet is installed!
2
ROUGHING-IN DIMENSIONS:
NOTE: Distance from wall to closet flange centerline must
be as listed below:
For 4110 Tanks: A = 10" (254mm)
For 4114 Tanks: A = 14" (356mm)
FINISHED WALL
For all other Tanks: A = 12" (305mm)
A
5
FLANGE
POSITION TOILET ON FLANGE
a.
Unplug floor waste opening and install toilet on closet flange
so bolts project through mounting holes.
b.
Loosely install retainer washers and nuts. Side of washers
marked "THIS SIDE UP" must face up!
P r o d u c t n a m e s l i s t e d h e r e i n a r e t r a d e m a r k s o f A m e r i c a n S t a n d a r d I n c .
© A m e r i c a n S t a n d a r d I n c . 2 0 0 0
For These Two-Piece Toilets:
Ellisse 2184
Heritage 2176
Baby Devoro 2315
Adjustable Wrench
Flexible Supply Tube
SUPPLY
AS
REQ'D.
FINISHED
FLOOR
NUT
TAPERED
WASHER
CLOSET
BOLT
Deco 2059
Cadet III 13L 2650/2660
Sonoma 2454
Sealant
Closet Bolts
3
CLOSET FLANGE
A
CLOSET BOLTS
INSTALL CLOSET BOLTS
Install closet bolts in flange channel,
turn 90 , and slide into place 6"
(152 mm) apart and parallel to wall.
6a
CLOSET FLANGE
Tape Measure
Carpenters Level
4
SEALANT
WAX RING
INSTALL WAX SEAL
Invert toilet on floor (cushion to
prevent damage), and install wax
ring evenly around waste flange
(horn), with tapered end of ring
facing toilet. Apply a thin bead of
sealant around toilet base.
INSTALL TOILET
Position toilet squarely to wall
and, with a rocking motion, press
bowl down fully on wax ring and
flange. Alternately tighten nuts
until toilet is firmly seated on floor.
!
CAUTION:
DO NOT OVERTIGHTEN NUTS
OR BASE MAY BE DAMAGED!
Saniwares
7 30 5 1 3 - 1 0 0 RE V . D