Page 2
Thank you for selecting American-Standard...the benchmark of fine quality for over 100 years. To ensure that your installation proceeds smoothly--please read these instructions carefully before you begin. All American Standard Products Are Water Tested At Our Factory. UNPACKING Some Residual Water May Remain In The Valve During Shipping.
Page 3
Note: All plumbing and electrical wiring must be installed in accordance (249mm) 9-3/4" with applicable codes, regulations and standards. (136mm) 5-3/8" CAUTION: Use only American Standard supplied (177mm) (173mm) 7" 6-11/16" transformers and cable sets. Using non-AS supplied MOUNTING...
Page 4
MOUNT CONTROL BOX; Fig. 4 Fig. 4 LAVATORY RIM OR Important: For AC installation, make sure power MOUNTING SURFACE supply connector is inserted into control box through power supply grommet before control box ENCLOSURE is mounted to the wall. Reference electrical 14"...
6. Replace CONTROL BOX COVER (1). Tighten cover Fig. 1d screws firmly. PWRX STANDARD BATTERY CAUTION: Use only American Standard supplied transformers and cable sets. Using non-AS supplied cables, or cutting, splicing or modifying any components will void the warranty. M965612 Rev. 1.8 (12/17)
Page 6
6b. Connect the10' EXTENSION (10b) to the POWER SUPPLY CABLE (15). Fig. 2c. 10' EXTENSION CAUTION: Use only American Standard supplied cable sets. Using non-AS supplied cables, or cutting, splicing or modifying any components will void the warranty. BLACK & WHITE...
Page 7
Max. of 15 Units on one AC POWER SUPPLY (7). 6. Replace CONTROL BOX COVERS. Tighten cover screws firmly. Fig. 3b CAUTION: Use only American Standard supplied transformers and cable sets. Using non-AS supplied cables, or cutting, splicing or modifying any components will void the warranty.
START-UP / MAINTENANCE Fig. 1 HAND WASH SENSOR OPERATION; Fig. 4 Prior to making power connection, make sure detection zone is not obstructed. Sensor is self adjusting. Keep detection zone clear for 15 seconds after power is connected. When the Sensor detects a user, the water immediately starts to flow.
Page 9
HOW TO CLEAN AND REMOVE Fig. 4 THE AERATOR OR SPRAY; Fig. 4 1. Remove Aerator or Spray HOUSING (7) with KEY supplied with faucet. 2. Remove Aerator or Spray (8) from HOUSING (7). 3. Clean the Aerator or Spray SCREEN (9). 4.