Rgb Cable; Connecting A Computer; Contents - Toshiba TLP-X10U Owner's Manual

Connecting a computer

You can project the picture from the computer.
Check that the power for the projector and computer is off before connecting the cables.
CONTROL USB MONITOR OUT COMPUTER IN 1
( Y/P
AUDIO AUDIO
OUT IN
To AUDIO IN jack
Notes
• The projector cannot be connected to a computer without an analog RGB connector. For details, refer to the computer manual.
• When connecting to a Macintosh computer, use the supplied Mac adapter (Multiple Scan 21 compatible). For some models the adapter is not required.
• You may not be able to connect some computers to the projector. For details, consult the dealer.
• Some computers may have output modes which are not compatible with this projector. Check the compatibility of the connectors, signal levels, timing,
resolutions, etc.
COMPUTER IN 2
)
/P
B R
VIDEO IN
R - AUDIO - L VIDEO S-VIDEO
To COMPUTER IN 1 connector
Be sure to connect in the proper
direction.
RGB cable (supplied)
Audio cable (supplied)
COMPUTER IN 1 Connector
For use as both analog RGB1 input and Y/P
factory, it is set for use as analog RGB1 input.
AUDIO IN jack
For use as both audio signals for RGB input (analog RGB1/analog
RGB2/digital RGB) and Y/P /P input.
B R
Connecting a Mac adapter for
Macintosh computers (supplied)
To monitor port ( )

CONTENTS

/P input. At shipping from
B R
Computer
ø3.5mm Stereo mini-jack
To audio output port
22