Advertisement
Installing the Rear Wire Harness
Bracket
1.
Remove the 2 flange locknuts (1/2 inch), 2
capscrews (1/2 x 4-1/2 inches), and 2 washers
(1/2 inch) that secure the hitch tube to the
receiver
(Figure
7).
1. Capscrew (1/2 x 4-1/2
inches)
2. Washer (1/2 inch)
3. Receiver tube
2.
Align the holes in the harness bracket with the
holes in the receiver as shown in
3.
Assemble the harness bracket to the clevis
with the 2 capscrews, 2 washers, and 2 flange
locknuts that you removed in step 1.
4.
Torque the locknuts and capscrews to 67 to 83
N∙m (91 to 113 ft-lb).
Figure 7
4. Flange locknut (1/2 inch)
5. Harness bracket
Figure
g280312
7.
5
Figure 8
g280309
Advertisement
