Advertisement
1. Taillight harness
2. Taillight-support tube
3
Assembling the Taillights
to the Machine
Parts needed for this procedure:
4
Capscrew (5/16 x 4 inches)
4
Washer (5/16 inch)
4
Flange locknut (5/16 inch)
Procedure
1.
Align the holes in the taillight-support tube with
the holes in the axle-frame tube as shown in
Figure
4.
Figure 3
3. Push-in fastener (harness)
g280317
1. Left taillight assembly
2. Right taillight assembly
3. Taillight-support tube
4. Axle-frame tube
2.
Secure the taillight-support tube to the
axle-frame tube
(5/16 x 4 inches), 2 washers (5/16 inch), and 2
flange locknuts (5/16 inch).
3.
Repeat steps
side of the machine.
4.
Route the left taillight wire harness inboard, and
insert the harness push-in fastener furthest from
the light into the 6 mm (1/4 inch) hole in the left,
upper gusset plate of the axle-frame tube as
shown in
3
Figure 4
5. Flange locknut (5/16 inch)
6. Capscrew (5/16 x 4
inches)
7. Washer (5/16 inch)
(Figure
4) with 2 capscrews
1
and
2
for the taillight at the other
Figure
5.
g280310
g280311
Advertisement
