Advertisement
1. Left taillight assembly
2. Push-in fastener (harness)
4
Installing the Wire Harness
Brackets
Parts needed for this procedure:
2
Wire harness bracket
Installing the Forward Wire
Harness Bracket
1.
Remove the 2 flange locknuts (1/2 inch), 2
capscrews (1/2 x 4-1/2 inches), and 2 washers
(1/2 inch) that secure the clevis to the hitch tube
(Figure
6).
Figure 5
3. Left, upper gusset plate
(axle-frame tube)
g280318
1. Flange locknut (1/2 inch)
2. Clevis
3. Washer (1/2 inch)
2.
Align the holes in the harness bracket with the
holes in the clevis as shown in
3.
Assemble the harness bracket to the clevis
with the 2 capscrews, 2 washers, and 2 flange
locknuts that you removed in step 1.
4.
Torque the locknuts and capscrews to 67 to 83
N∙m (91 to 113 ft-lb).
4
Figure 6
4. Capscrew (1/2 x 4-1/2
inches)
5. Harness bracket
Figure 6
g280308
Advertisement
