Figure 30 Removing The Faceplate Screws; Figure 31 Removing The Console Port Standoffs - Nortel 8660 SDM Installing

8
Use a Phillips screwdriver to remove the five screws that secure the front
faceplate to the 8660 SDM (see
Note: There are both fine-pitch and medium-pitch screws located along
the bottom edge of the 8660 SDM faceplate. Remove the five
medium-pitch screws only. These five screws secure the faceplate. Nortel
recommends using a Phillips #0 to remove these screws.

Figure 30 Removing the faceplate screws

9
Use a 3/16-inch nutdriver to remove the two console port standoffs (see
Figure 31).

Figure 31 Removing the console port standoffs

Chapter 4 Replacing a PrPMC 55
Figure 30).
Installing the 8660 Service Delivery Module (SDM)
11214FA
11215FA