Chapter 4 Replacing A Prpmc; Replacing A Prpmc On The 8660 Sdm - Nortel 8660 SDM Installing

Chapter 4
Replacing a PrPMC
This chapter describes the following topics:
Topic

Replacing a PrPMC on the 8660 SDM

Removing and installing a PrPMC filler panel
Replacing a PrPMC on the 8660 SDM
The 8660 SDM and PrPMC are sensitive to static electricity. Static discharge from
your clothing or other fixtures around you, even at levels that do not create a
spark, can cause damage.
To prevent static discharge damage when you work with the 8660 SDM or the
PrPMC, place each module on a grounded antistatic mat until you are ready to
install it, or leave the module in the sealed Electrostatic Discharge (ESD) bag.
Wear a discharge leash or wrist strap to free yourself of static before you touch a
module. You can add or replace a module with the power on or off.
To replace a PrPMC, start with the procedure described in
on page
Caution: Electrostatic discharge can damage hardware. Follow the
procedures in this section to protect your equipment from damage.
52. To install a PrPMC, see "Installing a PrPMC" on page
Installing the 8660 Service Delivery Module (SDM)
Page
51
65
"Removing a PrPMC"
59.
51