Installing a PrPMC
Remove the filler panel from the firewall iSD mini-slot, if necessary, before
beginning this procedure. See
Note: Nortel recommends that you remove the disk drive (if present)
located behind the PrPMC that you are installing before beginning this
procedure. See
Note: Ensure that iSDs are installed from right to left (that is, for a
FW1, the iSD is in slot 4 of the SDM FW1 tray; for a FW2, the iSDs are
installed in slots 3 and 4, and so on).
1
Place the 8660 SDM on an antistatic bag, or set it on an antistatic mat.
2
Hold the PrPMC with the components facing up (see
Figure 37 PrPMC with components facing up.
3
Place the PrPMC on an empty slot on the 8660 SDM.
"Removing a PrPMC filler panel" on page
"Removing a disk drive" on page
F I R E W
A L L
O nl in e
Ut iliz at
1
io n
2
Ac tiv ity
Installing the 8660 Service Delivery Module (SDM)
Chapter 4 Replacing a PrPMC 59
45.
Figure
37).
11220FA
66.