Table of Contents
Advertisement
28 Chapter 2 Installing the 8660 SDM
Preparing for installation
Before installing an 8660 SDM in a Ethernet Routing Switch 8000 Series chassis:
1
2
3
Removing and installing a chassis filler panel
Nortel ships the 8003, 8006, 8010, and 8010co chassis with a filler panel covering
each empty module slot.
Before you can install a new module, you must remove the appropriate filler
panel. For instructions, see
If you plan to remove a module from the chassis without immediately replacing it,
you can install a filler panel in the slot. For instructions, see
filler panel" on page
Estimated time to remove or install a chassis filler panel
The estimated time to remove a chassis filler panel is 10 minutes.
The estimated time to install a chassis filler panel is 10 minutes.
217314-B Rev 00
Unpack the 8660 SDM from the box.
Install the 8660 SDM according to instructions in this chapter.
Ensure that the first module is fully initialized prior to inserting the second (if
you are inserting an 8660 SDM in a chassis where another 8660 SDM is
already installed). See Firewall and Intrusion Sensor User Guide for
instructions to configure the 8660 SDM.
Note: On an 8003, 8006, or 8010 chassis, each filler panel covers either
one or three empty module slots. On the 8010co chassis, the filler panel
resembles a module and is installed in any empty module slot.
30.
"Removing a chassis filler panel" on page
29.
"Installing a chassis
Advertisement
Table of Contents
