Kohler K-45600X Installation And Care Manual page 5

Site Requirements (Cont.)
C. Bubble Area Construction Preparation (Optional)
Make sure you allow for access to the pump in the event the unit requires service. When constructing the
framing, allow for the thickness of sub and finish wall material (e.g. mortar mix and ceramic or marble tilling).
Drop In Installation: Refer to rough-in notes for cutout details. Make sure the bubble is supported by the
supporting feet on the bottom of the bubble.
Do not hang the bath by the rim.
Before Installing the Bath
Your new bubble has been manufactured to the highest possible standards, it has been factory tested and
¨
approved.
When removing bath from protective carton . DO NOT LIFT BATH BY PIPE WORK. Inspect for any possible
¨
damage that may have occurred in transit. Position a clean drop cloth or similar material in the bottom of the
bath to pretect the finish. Be careful not to scratch the surface of the bath.
Identify blower and switch access location before proceeding with installation.
¨
NOTE: NO BLOWER AND SWITCH ACCESS NOWARRANTY SERVICE. Ventilation must be provided to
access panel in order to allow heat from blower to dissipate. Jalousie access is recommended.
IMPORTANT: Bath must be installed level on all top edges.
Install the Bath
CAUTION: Risk of product damage. Do not lift the bath with airjets by the air channels or blower
motor, or use the air channels or blower motor for structural support of the bath.
CAUTION: Risk of product damage. Do not support the bath by the rim.
If the subfloor is not level, shim the bath support blocks as necessary.
A. Choose to Use Concrete or Mortar Bed
NOTE: Do not use gypsum concrete or drywall compound for this application, as they will not provide
an acceptable, durable bond.
Spread a 50 mm thick layer of cement or mortar on the subfloor where the bath will be set. This will help
¨
secure, level, and support the unit.
Brush a layer of waterproof paint on top of the cement or mortar bed.
¨
With help, carefully lift the bath into place.
¨
Insert the drain tailpiece into the floor drain. Make sure the bath is level and all feet are sufficiently supported.
¨
Remove the protective tape from the rim.
¨
Kohler Co.
Bath Rim
2 mm Gap
Between Bath Rim and Framing
5 1198675-X2-A