Function And Communication Modules That Can Be Used In A Redundant Configuration - Siemens CPU 410-5H Process Automation System Manual

Function and communication modules that can be
used in a redundant configuration
A complete list of all modules approved for PCS7 V8.0 SP1 is available at the following
address: SIMATIC Process Control System PCS 7 Approved Modules (V8.0 SP1)
(http://support.automation.siemens.com/WW/view/de/68157377/0/en)
In redundant configuration you can use the following function modules (FM) and
communication processors (CP) with a CPU 410-5H.
Note
There may be further restriction for individual modules. Refer to the information in the
corresponding product information and FAQ, or in SIMATIC NET News.
FMs and CPs which can be used centrally
Module
Function module FM 458-1 DP
Communication processor
CP 443-1 Multi (Industrial Ethernet
ISO and TCP/IP, 2-port switch)
Without PROFINET IO and
PROFINET CBA
Communication processor CP 443-
1 Multi (Industrial Ethernet ISO and
TCP/IP, 4-port switch, gigabit port)
Communication processor
CP 443-5 Extended (PROFIBUS
DPV1)
1) 2)
Only these modules should be used as external master interfaces on the PROFIBUS DP.
1)
These modules support DPV1 as external DP master interface module (complying with
2)
IEC 61158/EN 50170).
CPU 410-5H Process Automation/CPU 410 SMART
System Manual, 10/2013, A5E32631667-AA
Order No.
6DD 1607-0AA2
6GK7 443-1EX20-0XE0
6GK7 443–1EX30–0XE0
6GK7 443–1GX30–0XE0
6GK7 443-5DX04-0XE0
6GK7 443-5DX05-0XE0
Release
As of firmware 2.0.0
As of product version 1
As of firmware V2.1
As of product version 1
As of firmware V1.0
As of product version 1
as of firmware V3.0
As of product version 1
As of firmware V6.0
As of product version 1
As of firmware V7.1
B
One-sided Redundant
Yes No
Yes Yes
Yes Yes
Yes Yes
Yes Yes
Yes Yes
305